Fantabulous Krunk

This was made because my camper's under storage latches keep breaking, but just the top part and then only the hold tab. There was no need to make the base because the part that keeps breaking is the end tab of the top latch not the one bottom one which is usually attached with rivets. I suspect that this should fit most standard latches. just use the same hardware that was in the original and install it in the new one. I took the RV Latch made by marcsulf, and published Jun 5, 2012 and made it narrower so that the tabs would fit my camper's base, then I added side rails to keep the same outside appearance. By the way, thanks marcsulf for publishing your part, it saved me a lot of work not to mention $15. Thanks This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/bfuXFlLOXTa