Thingiverse
Fantasy Terrain Watchtower
door TwoRoads
116
Downloads
84
Likes
0
Makes
This is a 2 piece tower, built so that the main tower is hollow but with a top that has a solid floor for gaming. I was a little overzealous when I started building so the base model is likely too big for a lot of printers. At 60% this fit my Prusa Mk2 perfectly.
This printed fine for me with no supports.
This is my first large build so there are definitely things I might have done differently, you may or may not like how the top of the tower looks when seated on the base. The fit of the top onto the base is pretty good, it isn't a tight fit or snap in, but fits without a lot of wiggle room.
This printed fine for me with no supports.
This is my first large build so there are definitely things I might have done differently, you may or may not like how the top of the tower looks when seated on the base. The fit of the top onto the base is pretty good, it isn't a tight fit or snap in, but fits without a lot of wiggle room.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
