Slicer Discord
Fantin SD Board Mount – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Fantin SD Board Mount

0 Downloads
0 Likes
0 Makes
Zum Modell
A simple case mount for a Fantin SD Board which doesn't come with any Mount holes.Post-PrintingAfter printing, tap a thread into the 3mm hole (my printer always prints holes about 0.2mm smaller, otherwise 3mm would be too big) with a metal M3 screw. Use a Nylon M3 x 5-10mm screw to secure the SD board in the mount. Screw the mount to the backside of your case panel. Done!Category: Electronics
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nylon
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Highcooley veröffentlicht auch auf

32 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen