Thingiverse
FarmBot Endstop
von Blenderlab
4
Downloads
4
Likes
0
Makes
A simple endstop for Farmbot (express, but other might work). The same piece is used for the 3 axis.
Just insert a round push button (8mm), and connect-it to the motherboard endstop pins, between GND & Signal (upper & lower pins regarding front).
Don't forget to activate the Endstop in Farmbot settings, and you're done !
Just insert a round push button (8mm), and connect-it to the motherboard endstop pins, between GND & Signal (upper & lower pins regarding front).
Don't forget to activate the Endstop in Farmbot settings, and you're done !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!