Thingiverse
Fast PLA temp test
por JugaadGr
108
Descargas
52
Likes
2
Makes
Gcode ready to print on Anet A8, scaled down 50% of source in order to print in almost half an hour.
STL file is same as source just scaled down 50%.
You can use the gcode as is, it worked ok on my Anet A8. Using a Gcode injector to insert the temperature steps makes it look messy in the file but it prints fine and performs temperature steps as instructed.
STL file is same as source just scaled down 50%.
You can use the gcode as is, it worked ok on my Anet A8. Using a Gcode injector to insert the temperature steps makes it look messy in the file but it prints fine and performs temperature steps as instructed.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
