Fast & simple customizable cable tags

I wanted a simple cable tag that is easy to print and readable from both sides. It prints fast (only 6 layers, about 1-2 minutes if printing in bulk) and uses less than 1g of filament. Once printed, you just bend it in the middle. I also used a bit of glue to keep it together on the other side, but it shouldn't be necessary as the zip tie should hold it together.I ended up using color coding, e.g. blue for ethernet, red for power, etc, so it's even more obvious what is what. Also, I tried keeping the label as short as possible (7-8 characters), for practical reasons. The hole fits zip ties up to 6mm in width.If you want multi-color, change the last layer filament. Note: Compared to the photos, I had to change the font to a one supported by the MakerWorld customizer, but it should look similar.