Fast Tolerance Calibration Object

This is a 20 x 20 x 10mm rectangular prism that prints very fast and I use during calibration of flow rate. Typically I do this after calibrating extruder steps, it's important that your e-steps are already calibration otherwise it can interfere with the results here.

# Slicer Settings

- Set walls to 2
- Set Infill to 0%
- Set top and bottom layers to 0

After printing with the settings above if your line width in the slicer is set to 0.45mm you would expect the walls to measure 0.90mm since it's set to 2 walls. You can also do the test with a different number of walls if you want to.

If you don't get the expected results adjust your calibration and try again.