Thingiverse
Fastball
di helno
33
Download
25
Likes
0
Makes
This is a 200mm MTM racing quad. It is a tight fit to get everything inside so not a great beginner build.
The arms and two central plates are designed to be made out of carbon fiber and are available for purchase here. Arms to clear 6" props are also available.
https://armattanproductions.com/pages/kit_detail/57
Might make a few more changes to the dome for access to the USB port and to fit the VTX or any recording camera a bit better.
Bunch of pictures here.
http://imgur.com/a/bFTxA
The assembly goes something like this. The arms spacer and baseplates are bolted together with the two inside holes on each arm with the heads of the bolts facing down.
The bottom dome has the XT60 connector and wiring installed and then the PDB is installed.
Camera is mounted to the upper dome.
The arms and center plates are now attached to the bottom dome and any motor wiring can be completed.
Install the flight controller and figure out where you are going to fit everything
The arms and two central plates are designed to be made out of carbon fiber and are available for purchase here. Arms to clear 6" props are also available.
https://armattanproductions.com/pages/kit_detail/57
Might make a few more changes to the dome for access to the USB port and to fit the VTX or any recording camera a bit better.
Bunch of pictures here.
http://imgur.com/a/bFTxA
The assembly goes something like this. The arms spacer and baseplates are bolted together with the two inside holes on each arm with the heads of the bolts facing down.
The bottom dome has the XT60 connector and wiring installed and then the PDB is installed.
Camera is mounted to the upper dome.
The arms and center plates are now attached to the bottom dome and any motor wiring can be completed.
Install the flight controller and figure out where you are going to fit everything
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
