Thingiverse
Fat Shark Skyzone Wall Mount
di confuzled
3
Download
0
Likes
0
Makes
This is a modified version of the Fatshark Wallmount (by Lotstrand) which is itself, a modified version of the Fat Shark Hanger (by 3DJakob)
Fatshark Wallmount - https://www.thingiverse.com/thing:3578217
Fat Shark Hanger - https://www.thingiverse.com/thing:2739886
Where Lotstrand modified the base thickness to improve strength, this modification adds a recess for the screw heads for a cleaner look as well as access through the front of the mount for the use of a screwdriver.
Additionally, somewhere along the line in the original remix development, an angle was added to the base which makes the base need support no matter the orientation. This has been corrected in this remix.
My print time (with supports) is 6 minutes longer than the original (using my draft speed setting on both) with smart fill support enforcers for 25-degree overhangs. Your printer capabilities may not allow for such a low overhang angle so please consider your own limitations.
As a side note, if a
Fatshark Wallmount - https://www.thingiverse.com/thing:3578217
Fat Shark Hanger - https://www.thingiverse.com/thing:2739886
Where Lotstrand modified the base thickness to improve strength, this modification adds a recess for the screw heads for a cleaner look as well as access through the front of the mount for the use of a screwdriver.
Additionally, somewhere along the line in the original remix development, an angle was added to the base which makes the base need support no matter the orientation. This has been corrected in this remix.
My print time (with supports) is 6 minutes longer than the original (using my draft speed setting on both) with smart fill support enforcers for 25-degree overhangs. Your printer capabilities may not allow for such a low overhang angle so please consider your own limitations.
As a side note, if a
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!