Thingiverse
FaucetFalls
by Labadorium
4
Downloads
8
Likes
0
Makes
This should be a tight fit to 24mm faucet-outlets.
Since my one and only printer is set up for fine prints atm and not for speed,
i did not testprint this one YET.
If someone is eager to try, according to the slicer (ideamaker) it should take ~22g.
(.2 nozzle, .1 layerheight, 10% infill, 6 shells, 6 bottom, 8 top = ~12h print)
^----these are my actual settings, would be a waste of time for this very unfine object...
Since my one and only printer is set up for fine prints atm and not for speed,
i did not testprint this one YET.
If someone is eager to try, according to the slicer (ideamaker) it should take ~22g.
(.2 nozzle, .1 layerheight, 10% infill, 6 shells, 6 bottom, 8 top = ~12h print)
^----these are my actual settings, would be a waste of time for this very unfine object...
Labadorium also publishes on
3 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
