Thingiverse
FC & ESC mounting
par fpvframe_ch
15
Téléchargements
12
Likes
0
Makes
PRINT IN TPU =)
Here are all the files listed we use for FC and ESC mounting. Its based one 4 long screws holding the stack together.
Below the esc is a tpu part to create enough distance between cfk and esc and to hold the screws in place so they dont fall out when something needs to be repaired.
The TPU part on top of the flightcontroller servers as counter thread to the screws so there's no additional nuts needed. Also the design of this part makes mounting a small rx and tx on top of the stack very convenient.
The sidecover files are a special idea to protect the stack against dirt. The two hatches on both sides of the fc file are meant to be folded downwards and inserted into the latch of the esc file. It works but it might be a little inconvenient.
Here are all the files listed we use for FC and ESC mounting. Its based one 4 long screws holding the stack together.
Below the esc is a tpu part to create enough distance between cfk and esc and to hold the screws in place so they dont fall out when something needs to be repaired.
The TPU part on top of the flightcontroller servers as counter thread to the screws so there's no additional nuts needed. Also the design of this part makes mounting a small rx and tx on top of the stack very convenient.
The sidecover files are a special idea to protect the stack against dirt. The two hatches on both sides of the fc file are meant to be folded downwards and inserted into the latch of the esc file. It works but it might be a little inconvenient.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
