FDL-3 Sparrow Mod

This is a Remix of the FDL-3. Those files can be found on https://www.projectfdl.com/

I still need to test the "cap rear".

A #10-32 x 3/4 screw will be need for the underbelly and handle core to be screwed together.

The hole for the momentary switch is meant for this: Mouser # 633-FB15ANEP2
https://www.mouser.com/ProductDetail/633-FB15ANEP2

The rev trigger switch is meant to be swapped with this: Mouser # 653-V-212-1C6
https://www.mouser.com/ProductDetail/653-V-212-1C6
(Sold be some 3rd part Nerf stores as well)

A Stryfe rev trigger spring is meant to sit between the rev trigger and the switch.

Some filing/sanding will be need on the barrels.

Motor plates are meant to print flat-side-down with supports.

Use silicone grease on the pusher. Not only the gear teeth, but the top and bottom on the front as well.

Wiring the Voltmeter switch:
Solder 2 small wires to the momentary switch (633-FB15ANEP2) and feed the wires through to hole on the side of the handle