Thingiverse
Feather Holder
von ostopme
7
Downloads
0
Likes
0
Makes
Attach craft feathers to a motor.
The motor this is designed for is a standard 3.3v hobby motor, and the feathers should slot into the holes around the outside of the perimeter pointing inwards.
The fit for the motor into the feather holder might be quite tight depending on your printer settings, so keep a 2mm drill-bit handy to enlarge if necessary.
In the picture, I'm using M4x25mm bolts and an elastic-band to hold the motor in place, if you upgraded to M4x50 or even M4x75 then you could use these holes for mounting the entire assembly onto something more "structural".
The motor this is designed for is a standard 3.3v hobby motor, and the feathers should slot into the holes around the outside of the perimeter pointing inwards.
The fit for the motor into the feather holder might be quite tight depending on your printer settings, so keep a 2mm drill-bit handy to enlarge if necessary.
In the picture, I'm using M4x25mm bolts and an elastic-band to hold the motor in place, if you upgraded to M4x50 or even M4x75 then you could use these holes for mounting the entire assembly onto something more "structural".
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!