Feather Tiny box

This is a very small box for the Adafruit Feather micro controllers. if you dont need space for a lot of electronics, this might be all you need.

Hardware:
- M3 Flat head
- M2.6x5 button

For mounting, There are 2 M3 countersunk holes in the bottom, I used these to mount slider blocks but could be used to screw it to any number of things.

To bolt on the top, i used some M2.6x5 screws that i had from RC, partially because i had them, partially because they were adorable as all frig. i think a slightly more "standard" M2.5 would also fit. Not that that is a easy standard either.

One thing i never went back to adjust that could be fine tuned is the clips on the side of the bottom to secure the board in without screws.