Felix 3.0 3D Printer Light Bar Mod

This light bar is designed for the Felix 3.0 3D printer, It was designed to pivot up and out of the way allowing for easy accesses to the extruders. The Felix also had the duel extruder kit which means it will only work with Felix printers with that kit installed. The LED lights that were used were common 8mm wide strip lights, thay can be found on ebay or even automotive stores (if you want to pay to much)...
To get the lights to work I wired them into the 12v powered fan that is on the extruder, and added a on/off switch. You could however, run a few extra wires through the wire bundles back to the base and add a unit that would allow for dimming.