Hobby
Go to Model
Female XT60 connector
404
Downloads
309
Likes
1
Makes
Seems that there wasn't any on thingiverse. So I found one here https://grabcad.com/library/xt-60-female-connector-1 and made STL.
You need to drill holes with 4.5mm bit and slightly enlarge back side of holes, say 5.5-6mm bit few mm deep. This way 3.5mm bullets go in easily but you have to push/hit these all the way in so they stay secure.
Seems to fit male connector quite tightly. If it's too tight scale down by few percent.
You need to drill holes with 4.5mm bit and slightly enlarge back side of holes, say 5.5-6mm bit few mm deep. This way 3.5mm bullets go in easily but you have to push/hit these all the way in so they stay secure.
Seems to fit male connector quite tightly. If it's too tight scale down by few percent.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!