MakerWorld
Garden
Zum Modell
Fence Cable Clip / Spacer
3
Downloads
1
Likes
2
Makes
I needed a solution to keep the cable for my solar pump in place against our fence.I designed this spacer / clip to press in between the fence panel and the slot in the concrete post, and keep the cable in place in the slot.This clip should fit standard (UK) close board panel fence and concrete post solutions. You can adjust the thickness with the bambu studio scaling tool if this doesn't immediately fit your fence.This should work for most solar based lights, pumps, etc. Disclaimer: I would not recommend this for high voltage cabling, as there's always a risk of pinching or scuffing the cable. I used PLA for this, as this is not a stress part and should be more than sufficient for outdoor use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!