Thingiverse
Fence post cap
par MrBubbley
7
Téléchargements
5
Likes
0
Makes
I printed this with a brim but no supports. Prints fine.
Sometimes the 4X4 posts are slightly different sizes. If they were too small on one side then I shaved the very top of the side edge to fit.
There are small holes in the sides so you can nail down or else use thick glue.
Sometimes the 4X4 posts are slightly different sizes. If they were too small on one side then I shaved the very top of the side edge to fit.
There are small holes in the sides so you can nail down or else use thick glue.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !