Thingiverse
Feniex 4200 Mini Controller Template
von _JustGrant
7
Downloads
6
Likes
0
Makes
This is a drilling template to mount the Feniex 4200 Mini controller from the back.
Use a 3/16" drill bit and then enlarge the center hole for the wire bundle coming out the back of the controller.
8-32 screws and washers to mount the controller.
the angles on the corners are off a bit, but the overall size is correct to help give you an idea as to where it can fit.
Use a 3/16" drill bit and then enlarge the center hole for the wire bundle coming out the back of the controller.
8-32 screws and washers to mount the controller.
the angles on the corners are off a bit, but the overall size is correct to help give you an idea as to where it can fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!