Thingiverse
Feral Cat Pin
von FightFascism
0
Downloads
3
Likes
0
Makes
This little trivet is perfect for a magnet or pin.
The color changes can be done with an AMS, but they are all at the layer lines, so they can also be done by simply inserting pauses into the gcode.
For this one, there are two color changes:
Layer 11 or 2.2mm, and
layer 12, or 2.4 mm (final layer)
(This will work best it the color on top is not much lighter than the base color of the print)
The color changes can be done with an AMS, but they are all at the layer lines, so they can also be done by simply inserting pauses into the gcode.
For this one, there are two color changes:
Layer 11 or 2.2mm, and
layer 12, or 2.4 mm (final layer)
(This will work best it the color on top is not much lighter than the base color of the print)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!