Thingiverse
Fibaro motion sensor ceiling bracket
by Aoturoa
2
Downloads
5
Likes
0
Makes
No supports needed to print.
Push the motion device in from the top.
Rotate the motion device so only the sensor is exposed through the hole.
Best apply in gypsum board.
Cut a 65 mm hole and push the bracket in.
Push the motion device in from the top.
Rotate the motion device so only the sensor is exposed through the hole.
Best apply in gypsum board.
Cut a 65 mm hole and push the bracket in.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!