Thingiverse
Fidget Spinner Turbine
von mistertech
22
Downloads
12
Likes
0
Makes
I designed this to add a little bit of air movement while spinning. It doesn't move much air but it looks interesting and will spin if a lot of air is blown on to it (shop vac, etc).
*Use supports for the turbine blades. It's very easy to remove the supports as it only needs a tiny bit.*
I also designed concave bearing covers so the spinner won't slip out of your hand while spinning.
The bearing covers also have a small lip to prevent the covers from accidentally touching the bearing and slowing it down. You can squeeze these covers firmly without deforming them and slowing the bearings.
***Use my Spinner Press to help insert the bearings. http://www.thingiverse.com/thing:2275122***
*Use supports for the turbine blades. It's very easy to remove the supports as it only needs a tiny bit.*
I also designed concave bearing covers so the spinner won't slip out of your hand while spinning.
The bearing covers also have a small lip to prevent the covers from accidentally touching the bearing and slowing it down. You can squeeze these covers firmly without deforming them and slowing the bearings.
***Use my Spinner Press to help insert the bearings. http://www.thingiverse.com/thing:2275122***
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
