Thingiverse
Fidget Spinner
von phrogg111
4
Downloads
1
Likes
0
Makes
This fidget spinner was designed at CSUS by the SME club, during our first meeting.
Tolerances are set so the holes are 22.15mm. On a Printrbot Simple Metal, with a heated bed, this allows for a simple friction fit.
The first make of this will be finished on 19 May 2017, as proof that the SME club at Sac State will refuse to do things only in theory.
Tolerances are set so the holes are 22.15mm. On a Printrbot Simple Metal, with a heated bed, this allows for a simple friction fit.
The first make of this will be finished on 19 May 2017, as proof that the SME club at Sac State will refuse to do things only in theory.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!