MakerWorld
Other Toys & Games
Ver Modelo
Fidget Toy: "Candy Cane"
540
Descargas
182
Likes
432
Makes
This is the fidget toy you need for the upcoming Christmas gatherings! Relieve your anxiety and stress whilst showing the Christmas spirit. After that, hang it on the tree. 😀 This is a pretty straightforward print-in-place design and should move easily after printing. Ensure your printer works as well as possible and ensure the first layer adhesion. The new Bambu Cool SuperTack plate works well for PLA & PETG. Tips for successful canesEnsure that the filament is calibrated for Flow Dynamics and Flow Rate. Use Bambu Studio to perform both of these calibrations and then ensure that the new filament profiles are used in the print.Make sure that the build plate is clean and in good order so that the parts can stick fully. Any lifting during printing could affect the joints.Be sure to allow the print time to fully cool before breaking the joints loose. If the plastic is still slightly soft in the middle of the joints, it will tend to break off.Do not adjust the print speed to be higher (no
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!