Fidget Toy with Gears

This is a small fidget toy with gears that simply clips together as per the images Clip the 2 arms to the large gear. put the small gear on the shaft of one of the arms and then squeeze the arms together. This can take a little force as its a tight friction fit to stop it falling apart when spinning it. This has to be printed in the orientation that is set in the print profile for strength and needs to be printed with supports. Make sure these supports are fully removed to enable smooth operation. If the small gear feels tight on the shaft you may need to use a scraper to smooth the middle part of the shaft out. Be careful to not remove too much from the end as that needs to be a tight fit into the other arm.