MakerWorld
Vehicles
Model downloaden
Fiesta ST AccessPort V3 Mount
39
Downloads
13
Likes
23
Makes
This is a mount for use with the Ford Fiesta ST. It is a two-piece print that utilizes the cradle that is included with the AccessPort V3. This print took a lot of tweaking to get the fit perfect for my vehicle so it may not fit properly since all printers are slightly different. Try increasing or decreasing the overall scale of the print a few percent if it doesn’t fit properly the first time. Should hold your AccessPort V3 securely even in race conditions. Includes generic phone mount adapter, works with some phone mounts.Use slow mm^3/s value to prevent warping with ABS/ASA, I use 8mm^3s PRINT IN ABS/ASA OR OTHER STRONG MATERIAL. PLA WILL DEFORM IN HEAT OF THE VEHICLE.
mdt623 publiceert ook op
6 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!