MakerWorld
3D Printer Accessories
Zum Modell
Fifine Mixer Stand
57
Downloads
14
Likes
8
Makes
This is a useful stand for the Fifine Mixer, the mixer usually comes flat, and this stand will tilt it to a 45* angle. This stand has additional support beams and was built to not fall over. It has 3 indentations for grip, and design, and in the center is a hollow part to input wires, cables, etc and to limit the amount of filament it takes up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!