Thingiverse
Figure display stand with lattice risers
door ThomPerry63
13
Downloads
11
Likes
0
Makes
Four-Platform staggered display stand for figures.
Round bases from 25-32mm should fit inside the fingers, the figures I show here have much larger bases sitting on top of the fingers.
Platforms at 25, 50, 75 and 100mm
To demonstrate the strength/stiffness of the design, I put 2" diameter steel ball bearings on the three tallest platforms for one of the pictures. I don't think I'd want to leave that much weight on printed resin risers, but they seemed stiff enough.
In one screen-shot, I show five of these arranged to keep pattern spacing (just shy of 64mm center-to-center keeps the riser pattern).
I like the look of this smoky gray resin.
I had the slicer add drain holes at the center of each riser so any resin trapped in the base would drain easier.
Round bases from 25-32mm should fit inside the fingers, the figures I show here have much larger bases sitting on top of the fingers.
Platforms at 25, 50, 75 and 100mm
To demonstrate the strength/stiffness of the design, I put 2" diameter steel ball bearings on the three tallest platforms for one of the pictures. I don't think I'd want to leave that much weight on printed resin risers, but they seemed stiff enough.
In one screen-shot, I show five of these arranged to keep pattern spacing (just shy of 64mm center-to-center keeps the riser pattern).
I like the look of this smoky gray resin.
I had the slicer add drain holes at the center of each riser so any resin trapped in the base would drain easier.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
