Thingiverse
FiiO K11 Base
von xylite
1
Downloads
4
Likes
0
Makes
This is a simple base for the FiiO K11 amp/dac. I made this to help keep the amp from tilting and sliding around.
There's divots in the corners for 20mm double-sided adhesive dots. Any double-sided adhesive should work, or you could just set it on top. I printed in TPU, but PLA should be fine too. I would test print a chunk of it to test the height in case it needs any vertical scaling.
There's divots in the corners for 20mm double-sided adhesive dots. Any double-sided adhesive should work, or you could just set it on top. I printed in TPU, but PLA should be fine too. I would test print a chunk of it to test the height in case it needs any vertical scaling.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
