Thingiverse
FIIO X5 II Case
von bobusbobus
0
Downloads
2
Likes
0
Makes
Quick remix to add buttons & charging port.
Should be printed from pretty flexible TPU - like 92A, 90A or 87A. (98A is too stiff to insert the device).
Case is tad larger than player itself - play is less than 1mm in vertical direction (remember, it's just remix), but good enough for continuous use.
Should be printed from pretty flexible TPU - like 92A, 90A or 87A. (98A is too stiff to insert the device).
Case is tad larger than player itself - play is less than 1mm in vertical direction (remember, it's just remix), but good enough for continuous use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!