Thingiverse
FilaClip
door Indigo3D
2
Downloads
1
Likes
0
Makes
Use this to clip the end of your filament to the spool! This will ensure that the spool does not unwind, causing tangles.
Many of my prints were coming out with lots of over- and under-extrusion on different layers. I realised this is because the filament was tangled and the direct drive motor could not pull it through well.
Many of my prints were coming out with lots of over- and under-extrusion on different layers. I realised this is because the filament was tangled and the direct drive motor could not pull it through well.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
