Filacutter Filament Cutter

This is a small gadget I created to cut Filament. Whenever I changend Filaments, there are these alredy melted blobs at the tip of the Filament, and I never had a knife or a scissors around. So I came up with the Idea for this. The FilaCutter cuts the Filament at an Angle to make it easier to insert the Filament into the Extruder next time youre loading it. If you want to build one youreself, the only thing you need is the blade of an razor or an carpet Knife. Only criteria is that the blade must be between 4cm and 4,5cm long. If the blade doesnt fit, try heating it up and melting it into the plunger. I only tested the FilaCutter with PLA and TPU, but I think it should work with any kind of material, maybe even thin ropes.

P.S.: The picture shows an older version, the new one is not that thick at the bottom to save some Material.