Filadryer Wall Mount

This was designed for the Sunlu Filadryer to mount facing forward at a downward angle so it will feed directly into a direct drive setup on my printer without being to sharp of an angle to add excess drag. I designed this mount to work with the Filadryer but it should work with almost any filament dryer. it holds it at a 15 degree downward angle and can be bolted to the bottom of the dryer or used in conjunction with the thing https://www.thingiverse.com/thing:4833453 I bolted that to the brackets and the Filadryer will just sit in the cradle and will remain in place. I also use the angled PTFE mount for it to help with the angle. it can be found here https://www.thingiverse.com/thing:4717031 . this is a complete ground up design using Fusion360. the brackets are supposed to be printed twice. the top holes are left out so you can mark and drill your own. you do not need to use the separate Sunlu Fila Mate Dryer Holder if you don't want to. it can be bolted right to the top of this brac