Filament Box

My design of a filament box.

The box is found at my local Super Store, similar to the rubbermaid box but cheaper. The lid was slightly loose, so I added a layer of duct tape around the rim which gave it a nice tight seal.

Box Base is elevated for room to put in a large bag of Desiccant. To make the print quicker and easier, the design does not include the holes needed for airflow. Instead, I changed the print setting to print without tops or bottoms and infill of 10%. I added support blockers to change the infill of the legs to 100% with Tops and bottoms. You can use the 3MF file to import those settings.

The base is designed to fit the TUSH filament spool holder with room to spare. https://www.thingiverse.com/thing:2047554

Box Coupler is made to fit a 10mm coupler (same as hotend coupler). I also fitted 2*M3 screws to hold it in place. Simply drill or melt 3 holes using the coupler fitting as a guide. There is a front and back piece to give it a clean look.

Box Han