Filament Buffer Squeak Stopper

Hearing squeaking sounds coming from the back of your new P2S? Most likely, it's your filament buffer…Boost MeLike this model and want more like it? Let me know with a boost! Thanks!Filament Buffer Squeak StopperThe filament buffer can tend to make some squeaking sounds on long/slow extrusions due to slight misalignment with the outgoing PTFE tube. This can easily be fixed by correcting the alignment, and only takes a minute to do! The Filament Buffer Squeak Stopper solves this problem with only 1g of filament and 13 minutes of printing while using P2S included hardware. Just follow the simple assembly steps below, and the squeaks should disappear! Required Hardware:M3x8 screw (some are included with your printer, but any will do) Assembly Steps:Step 1:Remove the blue clip then pull out the PTFE tube from the back of your P2S. To remove the tube, depress the black ring while pulling out the tube. It should slide out easily.Step 2:Slide on the squeak stopper so that the M3 screw hol