Thingiverse

Filament Cleaner

von olafelch

5 Downloads

1 Likes

0 Makes

There are lots of fairly neat filament cleaners out there, but I put this together to fior my old RepRapPro (which is still doing great service!). Apart from the printed parts, you only need two 16mm M3 cap screws and two M3 nuts.

I've used the cleaner in a dry state, but there is a hole to allow you to moisten the sponge with a little mineral oil.

175mm filament 3D printing 8mm mount 8mm Threaded Rod filament cleaner mendel reprap reprappro 175mm filament 3D printing 8mm mount 8mm Threaded Rod filament cleaner mendel reprap reprappro 175mm filament 3D printing 8mm mount 8mm Threaded Rod filament cleaner mendel reprap reprappro 175mm filament 3D printing 8mm mount 8mm Threaded Rod filament cleaner mendel reprap reprappro 175mm filament 3D printing 8mm mount 8mm Threaded Rod filament cleaner mendel reprap reprappro

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat

STL

Material

Nachbearbeitung

Hardware

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Filament Cleaner

Zur Sammlung hinzufügen