MakerWorld
3D Printer Accessories
Go to Model
Filament clip.
13
Downloads
3
Likes
7
Makes
Small, simple and light, very practical filament holder on the spool, printing time under 10min and weight under 1g. For low-quality filaments that do not have the same 1.75 filament width, I recommend increasing the model by 1% to 2%. It is also possible to glue it to the edge of the spool. You stretch it when using it and squeeze it in the next thread and it holds. Never again will the filament eyes fall out.
PokeGeorg also publishes on
16 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
