Thingiverse
Filament Clip
von DarthBane
77
Downloads
40
Likes
1
Makes
It is barely changed from original (http://www.thingiverse.com/thing:12516).
It is a clip to hold your filament (1.75mm) ends on the spool.
When I printed the original, the hole came out too small, I couldn't insert the filament in it. Also it was a bit loose on my spools. So I redrew it and made the hole just a tad bigger, and the pinch on the spool a bit tighter.
This is a great clip, thank you to the original designer (Madox) for it!
It is a clip to hold your filament (1.75mm) ends on the spool.
When I printed the original, the hole came out too small, I couldn't insert the filament in it. Also it was a bit loose on my spools. So I redrew it and made the hole just a tad bigger, and the pinch on the spool a bit tighter.
This is a great clip, thank you to the original designer (Madox) for it!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
