Filament Clip

A slightly enlarged hole from the original, for some reason my printer keeps printing the hole too small; the original model does actually have a 2mm hole wich should be fine, but my printer keeps tightening it up, probably the higher speed and temperatures but i figured i just enlarge it a bit as other models seem to print good clearances.
Plenty seem to have had the same issue so i hope this helps someone, some suggest using a drill bit but that to me kind of defeats the purpose of a 3D printer.
Works perfectly for me now.

Tested on a Replicator 2(Sailfish) with 1.75 PLA.

Original Design by CountSpatula: https://www.thingiverse.com/thing:224791