Thingiverse
filament clip
door dav88
76
Downloads
59
Likes
0
Makes
i made this to hold the filament in place to keep from unraveling from the spool.
there are 2 ways to secure the filament:
1. is to push the filament into the top slot after tightening the clip to the spool.
2. place the filament into the lower slot as you tighten the clip to the spool. this will make sure it is securely tightened in place.
no supports.
there are 2 ways to secure the filament:
1. is to push the filament into the top slot after tightening the clip to the spool.
2. place the filament into the lower slot as you tighten the clip to the spool. this will make sure it is securely tightened in place.
no supports.
dav88 publiceert ook op
537 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
