Filament Clip

A simple low profile filament clip that works!!
I printed mine in TPU for AMS but they work just as effectively in PETG .. if not better.

Note: The attached print files have been slightly revised from the original upload.
The 'U' section has been angled in slightly more to give a better grip on the reel edge.

I have included two files ..
1. the updated original file
2. the same file with a slightly larger filament hole.
Note: I found printing in PETG had correct hole size but PLA was smaller probably due to shrinkage .. hence the 'oversize' file.

Trust these two files will suit now .. if they don't .. leave a 'comment' and I will modify again.

The included files are a .3mf (project) files, so filament used for your print may need changing but the other settings should remain.
My prints have been with 2 Walls .. Rectilinear patterns ..20% infill .. under 'Quality - Wall Generator'' tab I have selected 'Arachne' instead of Classic ..