Thingiverse
Filament Clipper (1.75)
von EliteNetworks
17
Downloads
66
Likes
0
Makes
This thing will allow you to cut/clip your filament at a near perfect 90 degree angle. I found that using wire snippers would leave a very non-flat edge, causing jams when filament was changed on the fly during a print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!