Filament Dry Container

Modified base with reduced slitsize to avoid smaller silica balls to get through them and added a new bracket for a hygrometerWill fit the following containerBracket works with the following hygrometer*I recommend using colour changing reusable silica gel to keep track of when to change the silicagelParts to printWhat you need:Print the Filament Base first (without supports) Print 2 RollerPrint one Silica Lid and check if it snaps to the baseDepending on the filament you may need to resize it in small (0,5 - 1,5%) steps Optional but recommended:Print the screws linked aboveDepending on the filament I would recommend to scale the nut up a bit so the thread goes easy.Print one Spacer for the temp-sensor/hydrometerFor bigger spools I'd recommend the original wedge above as it will push the sides better to fit bigger spools. ### Additional parts needed1 Drybox1 Hygrometer 4 608 ZZ Bearing (8mm x 22mm x 7mm) 1 Compression FittingAssemblyInsert 2 Bearings into each rollerMount both roller to