Thingiverse
Filament / Dust Filter
by madhead
2
Downloads
0
Likes
1
Makes
Yet another filament dust filter here. The best one, if you ask me!
* Simple snap-fit design
* No screws or other fasteners needed, only the printed parts (and a piece of sponge)
* Can be hot-mounted onto a filament without fully reloading it (i.e. you could snap it onto a filament at any place; you don't need to thread the filament's open end through it)
* Fully parameterizable design with a FreeCAD source attached
Useful? Consider… [](https://github.com/sponsors/madhead)
* Simple snap-fit design
* No screws or other fasteners needed, only the printed parts (and a piece of sponge)
* Can be hot-mounted onto a filament without fully reloading it (i.e. you could snap it onto a filament at any place; you don't need to thread the filament's open end through it)
* Fully parameterizable design with a FreeCAD source attached
Useful? Consider… [](https://github.com/sponsors/madhead)
madhead also publishes on
40 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
