Filament / Extruder Guide

Filament Guide!
Z Screw Avoidance!
Possibly Ninjas in the Dark!

Version 2 Uploaded!
Gave a good bit more tolerance to everything, Tested on 2 machines that are close but not exact.

To install Just use the Z screws. They are plenty long enough.
Tighten a bit, then raise and lower the Z height to test for binding. Test at various heights Just like when it was built. get just tight enough that no binding occurs.

Clip your Filament at the 45 Degrees with the open face matching the bowden tubes curve
and your filament will slide straight to the hot-end with no effort.

Part one of this project can be found here: https://www.thingiverse.com/thing:2917932