Thingiverse
Filament Guide Direct Drive
di DanChr89
31
Download
17
Likes
0
Makes
I needed a filament guide when I converted my ender 3 into micro swiss direct drive which had push-in couplings on both sides. So I could use my filament dryer.
Hardware Required:
2 x M6 Couplings
Approx. 30mm of 4mm bowden tube.
When printed clean the 4mm holes with 4mm drill bit. I cleaned the bigger holes for the couplings with 5,5mm drill bit, but I maybe think that its easier making M6 thread in them.
Edit: 15-09-20
I uploaded a single push-in version
Hardware Required:
2 x M6 Couplings
Approx. 30mm of 4mm bowden tube.
When printed clean the 4mm holes with 4mm drill bit. I cleaned the bigger holes for the couplings with 5,5mm drill bit, but I maybe think that its easier making M6 thread in them.
Edit: 15-09-20
I uploaded a single push-in version
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
