Thingiverse
Filament guide for MendelMax
door Amplivibe
7
Downloads
3
Likes
0
Makes
This is a "clamp-on-extrusion-and-fasten-with-bolts" type filament guide for my MendelMax. Very easy and simple design. I personally use it without screws and bolts, because it clamps quite well anyway.
The guide itself is open on one side, so you don't have to take out the filament if you put it in place. I taped it in place together with the isolation wool.
The guide itself is open on one side, so you don't have to take out the filament if you put it in place. I taped it in place together with the isolation wool.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
