Thingiverse
Filament Guide
door hbaulig
8
Downloads
3
Likes
0
Makes
I had lots of trouble lately with the filament tubes coming off at the back and the prints failed.
Then I designed a new filament guide to feed the filament from the middle of the spool and had no problems since.
You can use the existing screws to fit it and use a cable tie to locate the cables in the center.
Then I designed a new filament guide to feed the filament from the middle of the spool and had no problems since.
You can use the existing screws to fit it and use a cable tie to locate the cables in the center.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
