Slicer Discord
Filament Guide – 3D-Druckmodell von Thingiverse Thingiverse

Filament Guide

10 Downloads
8 Likes
0 Makes
Zum Modell
This started literally after I printed the most-excellent Spool Holders by MartinMajewski - (thing:1832235) - and after I got a 2kg spool of Prusa Orange NGEN. When that spool was full it kept wanting to dump a coil or two over the side.

That is why there are two ARMs for my new Filament Guide, one longer than the other. The long ARM for the 2kg spools and the short ARM for the 1kg spools. You don't need to print both ARMs if you don't have large spools. I made the short ARM so that the guide is pretty much the same distance out as the print head so that the filament path is straight down.

This Thing separates into two separate pieces. The RING is separate from the ARM. This is done for the obvious reason of make it easier to print. Since the two parts are separate, you can lay them both down directly on the bed for printing. And this allow the use of different length ARMs as described above.

I also started with the same mounting geometry that MartinMajewski used excep
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
50 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen