Thingiverse
Filament Guide
von WillErf
23
Downloads
11
Likes
1
Makes
I created this filament guide as I found other filament guides had some issues I wanted to fix.
1. I wanted the model to be completely printable. (no bearings) I found that the bearings in other filament runners didn't even spin, so why have them.
2. When the extruder would move to the left, I found that the filament guide would get pushed out of it's mounting hole, so I added a twist nob to lock it in place.
3. My final reason for making this design was that I wanted it to print in one piece.
Installation:
1. Remove the rafts if you used them.
2. Twist the nob to break free any connections that may have formed.
3. Press the filament guide (you may need to use a fair bit of force) into the hexagon hole.
4. Reach under and twist the nob just slightly to lock the filament guide in place.
1. I wanted the model to be completely printable. (no bearings) I found that the bearings in other filament runners didn't even spin, so why have them.
2. When the extruder would move to the left, I found that the filament guide would get pushed out of it's mounting hole, so I added a twist nob to lock it in place.
3. My final reason for making this design was that I wanted it to print in one piece.
Installation:
1. Remove the rafts if you used them.
2. Twist the nob to break free any connections that may have formed.
3. Press the filament guide (you may need to use a fair bit of force) into the hexagon hole.
4. Reach under and twist the nob just slightly to lock the filament guide in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
